![]() This will typically be one of: C:\Program Files (x86)\Atmel\Atmel\Studio\7.0\toolchain\avr8\avr8-gnu-toolchain\avr C:\Program Files (x86)\Atmel\Atmel Toolchain\AVR8 GCC\Native\3.\avr8-gnu-toolchain\avr C:\Program Files (x86)\Atmel\Atmel Studio 6.0\extensions\Atmel\AVRGCC\3. Libusb-win32 for the driver for the USBASP programmer: Īnd AVR Studio 5.1.208. First, determine the location of your avr-gcc files. ![]() The software you'll need, at least to see the same things I see on my screen (that helps when following a step-by-step), is: It will tell you if anything is left behind that was tied to the part you commented out. It gets more complicated if you want to do stuff like delete the ramping or strobe modes, you just have to comment out (add a '//' at the beginning of the line) the obvious stuff, then see if it builds without errors. You can edit the number of levels and their PWM values just the same. Then the Library Manager will open and you will find a list of libraries that are already installed or ready for installation. Open the IDE and click to the 'Sketch' menu and then Include Library > Manage Libraries. Luxdrv 0.30b works just the same, though the code is much more complex. To install a new library into your Arduino IDE you can use the Library Manager (available from IDE version 1.6.2). (PWM values under 5 only work with the FETs, 7135s will sometimes work at 4 but not always reliably stick to 5 as the lower bound for a 7135 driver) Uint8_t modes= //PWM values, 5.255 - LEAVE THE "0" THEREĪnd each short press will decrease one level instead of increase.) So take the line in the original that says: For a simple one like minimo all you have to change is the PWM levels.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |